简介:
WET VST湿压缩器v1.0.1 VST3 Windows Mac Linux [免费]
免费 | Windows Mac Linux | 6.52 MB
原汁原味的76型FET压缩器，电路级建模。反馈检测器、一个会削波的增益单元，以及随压缩程度增加而加剧的失真。
功能
–
两个控件
输入使信号超过固定阈值，输出则将这部分损失补偿回来。
–
三个时间
：快速、正常和慢速同时选择攻击时间和释放时间
–
阶梯式旋钮
: 每个21个棘爪，间隔3 dB，中心保持移位0 dB，持续1 dB
–
完全计量
立体声输入和输出峰值表以及增益衰减条
–
VST3自动化
: DAW中的完整参数自动化支持
–
可调整大小的用户界面
右键单击面板以进行界面缩放：75%、100% 或125%
FET机架式音色
–
反馈检测器
: 取自增益单元的输出，因此4:1是一个闭环比率，在阈值附近自行软化-无需拐点控制
–
循环延迟的一个示例
: 检测器无法看到样品，直到它已经通过细胞，所以一个瞬态的前沿通过
–
获得一个会到底的单元
: 降低38分贝的硬地板; 过去，更努力地驾驶会带来失真，而不是压缩
–
与压缩同步的失真
: 静止时为0.02%，在降低19 dB时为2.9%，因为设置增益的设备是制造谐波的设备
–
四个放大器
: 输入变压器，增益单元，单端A类前置放大器 (2次谐波)，推挽A类输出到输出铁 (3次)
–
双常数释放
：并行的快速路径和慢速路径，其中慢速路径的权重取决于归约的深度。
–
每级噪声与串扰
: 每个阶段都增加了自己的噪音，并泄漏到旁边的通道中; 总计-40 dB，-93.7 dBFS floor
–
元件公差
每声道为2.5%，因此两侧几乎不会出现两次完全相同的声道。
简介:
WET VST WetCompressor v1.0.1 VST3 WiN MAC LiNUX [FREE]
FREE | WiN MAC LiNUX | 6.52 MB
Authentic 76-style FET compressor, modelled as the circuit. Feedback detector, a gain cell that bottoms out, and distortion that rises with the compression.
Features
–
Two Controls
: INPUT drives the signal past a fixed threshold, OUTPUT puts back what that cost
–
Three Timings
: FAST, NORMAL and SLOW select attack and release together
–
Stepped Knobs
: 21 detents each, 3 dB apart, 0 dB at the centre – hold Shift for 1 dB
–
Full Metering
: Stereo input and output peak meters plus a gain-reduction strip
–
VST3 Automation
: Full parameter automation support in DAWs
–
Resizable UI
: Right-click the panel for UI Zoom – 75%, 100% or 125%
FET Rack-Style Character
–
Feedback Detector
: Taken from the output of the gain cell, so the 4:1 is a closed-loop ratio that softens on its own near the threshold – no knee control needed
–
One Sample of Loop Delay
: The detector cannot see a sample until it has been through the cell, so the leading edge of a transient gets through
–
Gain Cell That Bottoms Out
: A hard floor at 38 dB of reduction; past that, driving harder buys distortion rather than compression
–
Distortion That Tracks Compression
: 0.02% at rest, 2.9% at 19 dB of reduction, because the device setting the gain is the device making the harmonics
–
Four Amplifiers
: Input transformer, gain cell, single-ended class-A preamp (2nd harmonic), push-pull class-A output into the output iron (3rd)
–
Two-Constant Release
: Fast and slow paths in parallel, the slow one weighted by how deep the reduction went
–
Per-Stage Noise and Crosstalk
: Every stage adds its own noise and leaks into the channel beside it; -40 dB total, -93.7 dBFS floor
–
Component Tolerance
: 2.5% per channel, so the two sides are never quite the same channel twice
评论0